Ricon Catch Latch Base – RI60512

My dad needed a new Ricon Catch Latch Base – RI60512 as his was broken to pieces. Being as I did not have enough pieces to recreate it I discovered this cheap plastic block cost $50 USD shipped. I was not able to find a dimension sketch for it so I had to waste $50 to buy it. 500% overpriced. I decided to use the new part to design it and print it out of Dupont Zytel as it is a super strong Nylon and I have never found anything close to this material. So better to use a few dollars of the Dupont for this if you need it, and store the leftover in a dry place.

NOTE: Once you have printed it, you will need to run a 5/16 NC18 tap through the threaded holes. The plastic expands some when printing and the threaded hole will be slightly restricted. Dupont Zytel performs well being tapped.

Dupont Zytel 3D Filament 3D1000FL NC010:
https://www.matterhackers.com/store/l/dupont-zytel-3d-filament-3d1000fk-nc010-175mm-1kg/sk/MR0A4G7R

KIT,BASE CATCH,LATCH (CLASSIC) RI60512 (If you want to buy it):
https://donbrownbusparts.com/products/kit-base-catch-latch-classic-ri60512

Please share and enjoy!