Anycubic Predator E3D V6 with stock effector

First Versus3D wonderful design and Thank You for it.!!!!!

I loved this design for my predator since we all know how stock heat assembly sucks and how much of an upgrade it is to use a standard E3DV6.

In my case Im always messing with printers and threads in plastic will work but its hard to know whens too much torque and then bam you strip the threads.

I decided to try and combine this design with the stock effector.

Basically I dropped the design into fusion cut away the bottom half and left the top half added holes and a spot for M3x30mm screws and M3 nuts.

So this is not for the faint of heart you will be cutting away material from your stock effector

using Versus3D design as a template.

After cutting away the material you have to drill 2 through holes on the effector pretty much blind since the there wont be any guide on where to drill.

I suggest getting my model and only printing the first few layers then using that as a template.

Since the top hole with be horizontal with the 2 new holes its not hard.

Once thats done you need to counterbore the plate so the head of the screw sets flush since all the current fan shrouds use that area you can just use a bigger drill.

I also modified the plate where the level sensor mounts as you can see in the pics.

Ive used different fan shrouds and the best for me is from Bakak plus it uses 4020 fans which this design already has mount holes.

I did print using support only from the build plate and went 1% bigger scale because of the shrinkage in ABS. I do suggest anything near the hot end in ABS or PC

Hopefully that helps some of you that are brave enough to try.

Mine came out perfect.